- intake question
- 3/4 length chevelle headers
- Motor's makin' me mad.
- Almost a disaster with my 350 rebuild
- Yoke question
- Brake warning light?
- TH400 makes sound effects
- Is this too tight?
- Valve seal
- She Runs...
- Why the difference in these Rod Bearings?
- valve rotation?
- WTB:Performer RPM vortec intake
- Carb tuning problem
- Death of a Tranny?
- Crank bearing clearance
- 67-70 rearend length?
- Turbocharged 250-6
- tire/speedo calculations
- need driveshaft length or driveshaft
- sm465 $$$$$$$$$$
- It Runs!! It Runs!!! It Runs!!!
- Gas Milage
- Engine starts, but then goes dead (HELP!!)
- storing new engine
- Spun Rod Bearing: Correct fix??
- three speed (on the tree)
- TH 400 question
- PS what Pitman arm on 68???
- Sentry Tires ???
- Engine Upgrade questions...
- So...who here gets the best mileage (With their truck!)?
- CArb Recommendation-revisited
- Rear end yoke removal/reinstallation
- chevy astro
- W2t: Truck For A Engine
- lowering carrier bearing
- 700r and convertor ?
- odd 76GMC problem starting
- Plastigage
- recomended big block exhaust setup???
- 350 Rebuild Costs
- It's Alive!!!!!!!!
- Tranny Help
- 88 GMC suburban oil pan
- cooling problem
- Rad suggestions
- Putting diesel in gasser
- check this out
- Axle question
- 3 speed swap for 3 speed w/od
- Two piece driveshaft to One piece?
- sbc guideplates
- 1999 vortec 5.7 proformance mods
- I had a problem with my transmission this weekend, loss of fluid
- Motor install Question...
- pulley question
- tire question
- Ford Help
- trans is leaking
- Auto tranny questions
- Rethreading sets: Useful?
- Engine ID #'s
- I'm a noob that needs help please
- Got a SBC V8
- problems with idle/low rpm
- Holley Carb Users Please step in...
- TPI Intake vs. Performer with a 750; Which is best?
- Make 1 good carb out of 2?
- Piston rings
- Help need quick please?
- Anyone using a Holley Carb with a Performer Manifold?
- New intake question
- 1995 Engine Specs.
- HELP !!!! 350 hard to start I need Help!