We have a 62 c10 and I can get my hands on a built 350 roller motor and the guy has a tune port with new injectors and intake that can go with the motor.The engine is a 87 Iroc 350.I would love to hook it to a 700r4...what would I need to mount the tranny.
Our 62 is a 3 speed on the colume.
the engine is the straight 6 cyl.Where to go to get the correct motor mounts for the 350 and what Computer management system do i need for the TPI?

I did a custom tranny mount out of 1/4 inch metal plate runnin from side to side w/ bolt going thru the frame and the plate on each side for my muncie.

Street and Performance is a good source. They are a little spendy, but have quality pieces and good support.

Here is where I picked up my cross member for the 700R4. It is for the 63-72, I do not know what the difference would be. You could ask them, and see if they make it for the 62. http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&ih=018&sspagename=STRK%3AMEWN%3AIT&viewitem=&item=280037116884&rd=1,1 I have built my own cross members for other projects I have done in the past, but these seemed resonable enough for me not to mess with doing my own.

Vince,
Where, in Alabama, are you located?

We .I would love to hook it to a 700r4...what would I need to mount the tranny?

I put in a 350 (building a new 383 right now) and a 700R4, used 3" x 1/2" strap for the 700R4 crossmember, bolted from outer frame rail to outer frame rail, I can take some picks if you need them. as for motor mounts I am not sure if your 350 TBI is diffirent than the Non TBI I used?

Vince,
Where, in Alabama, are you located?

I am Blue Springs...between Abbeville and Clio.
Thanks guys for the info.I should have the engine next weekend.
Probably not going with the tpi,but use a carb the first time out.
Really like to use some kind of OD wit the engine