I was wondering if anyone had any pics of the headers they had on their inline 6. The pic im looking for is not from the top, but from the bottom, looking at the end of the headers, where the pipes start. Im trying to figure out what mufflers i can buy to use with the headers, but i don't know how far apart the header flanges are once they reache below the cab. Pic anyone? Thanks....

Brad

I will snap one for you this weekend.

thanks

anybody pics?

just get fenton slipt manifolds

NSX here you go :http://i98.photobucket.com/albums/l256/scan64/PDR_0098.jpg

http://i98.photobucket.com/albums/l256/scan64/PDR_0099.jpg

http://i98.photobucket.com/albums/l256/scan64/PDR_0097.jpg

mine is a 60 yours will not have the torsion bars.hope this helps
My exhuast spits tworsd the back, thats were my muflars are.
any good muffler shop will be able to bend an exhuast for you.

Hey, thanks a lot. I was looking at the headres and mufflers offered in LMC's catalogue, and was deciding on which mufflers to get. They had ones that were for bolting straight to the headres and ones that were normal. I was tryin to figure out if the ones witht the flanges that bolt right to the headers would fit, but i doubt it. Thanks for the pics, it helps me out a lot.


Brad

borndead327, what are those?

No prob nxs, here is a link to Fenton splits .....

http://www.stoveboltengineco.com/acartpro/product.asp?productid=131


but I dont think they make them for our 250.

Not Fentons, but a close second...

http://www.stoveboltengineco.com/acartpro/product.asp?productid=89