Luis_gz06
06-16-2008, 09:00 PM
I need the passenger side rear sliding window frame mount for a 66 Suburban.
The one it has right now, is rusted out!! Hopefully someone out here has one.
Its the frame that where the window slides through to close or open. I think it's bolted with a few screws on the body. Also if you have the latches to lock the window, that would be great too. Thanks and hopefully something comes up.
soba_03
06-18-2008, 06:19 AM
Luis,
was that you on Stovebolt? I thought someone over there had sliders that they were removing and trying to sell the frames... Check it out under the burb section...
Luis_gz06
06-18-2008, 11:45 AM
No, don't know what's Stovebolt.:confused:
soba_03
06-18-2008, 01:31 PM
www.stovebolt.com
You can go and view without creating a user account. But to post you have to create a user account. Just this past week in the (Burb) section I believe the actual title is "Panel's and Burbs" there was a fellow that was trying to sell slider frames. It's a good sight. But this site is much more active and is much more like your family. I don't know that one might be a little more stuffy.
It's got alot more stuff for I6 and 60-66 trucks because those were considered "Stovebolts"
Have a look you will most likely find what your looking for.
Regards,
Mark
Luis_gz06
06-19-2008, 11:57 AM
www.stovebolt.com
You can go and view without creating a user account. But to post you have to create a user account. Just this past week in the (Burb) section I believe the actual title is "Panel's and Burbs" there was a fellow that was trying to sell slider frames. It's a good sight. But this site is much more active and is much more like your family. I don't know that one might be a little more stuffy.
It's got alot more stuff for I6 and 60-66 trucks because those were considered "Stovebolts"
Have a look you will most likely find what your looking for.
Regards,
Mark
Thanks alot!! Ill try to look for them there, but ill still look here too.
Luis.
ratskin
06-25-2008, 05:10 AM
Those frames are fixed pretty easily. I welded in some small channel of the same width. If you're not a welder, you could probably find a shop to do it for the same or less than buying and shipping frames, and almost all that you'll find will have the same problem.
Captainfab
07-07-2008, 10:28 PM
I have some of those....give me a couple of days to see if what I have is in good enough shape.
Captainfab
07-15-2008, 04:58 PM
I've got one that so far appears to be in good shape, I still have to take out the glass and weather strip. Let me know if you still need one.