I need front solid side glass for my burban. I have a full set of sliders I would trade or will paypal. I need them asap and cheap as possable. My budget for this rust bucket is gone.

I talked to a Glass guy here in town and he has said that on a few of these they have just had glass cut for the side windows. When I asked about it he made it seem like it wasn't a huge deal. Might check with local glass shop. Are your sliders bad?

My sliders are ok, little rusty in the channels and no latches, but not to bad. I just want the cleaner look of solid glass. you need some sliders?

I hope I don't.... I mean I haven't pulled them yet... I got way to much going on with it right now to change direction for the 121st time.....So that will be comming in the future. Stick them in Hiding and I'll get a hold of you whem I pull mine...LOL

I would hope that with only 42999 actual miles that they aren't to bad... I know that the seals and felts are shot.. and the seals (the right seals) only place that I've found they at this point have been Steele and they want 500 for the 4 seals not felts but just seals... So I'm on a holding pattern till I get ready to paint inside and out.. It's going to be a while...

consider them hidin.

ttt

I'm not sure if they put solid glass in the front from the factory. The only ones I've seen are in the rear.

Yes they did, It was offered in many combos of slider/slider, solid/solid, slider/solid, solid/slider. I may have the rears cut down to fit.