View Full Version : '64 K-20 rolling chassis-complete - $300


Blue'66
12-27-2002, 01:14 PM
I just bought this truck from a friend for the front clip for my '65 k-20. The cab had been removed, it was trash, truck has no bed. Frame is complete with both axles, D-44 front(closed knuckle) and HD Eaton rear end. Still has both bumpers. Set up for SBC. SM-420 trans and T-221 transfer case, all seem to work well. All springs and shackles look good, frame is in very good condition, better than the last one I sold. Has all e-brake cables and they look good and are working. No motor, but has bellhousing. 4 16.5 inch rims, non split rims. All 4 tires hold air. Will deliver within a 100 mile radius. $300.00 Dont want to part out.

truckman32
01-15-2003, 04:45 PM
is it short wheel base frame

Blue'66
01-16-2003, 07:43 AM
No, it is a long wheel base 3/4 ton 4x4 frame.

Blue'66
03-10-2003, 11:58 AM
Still For Sale!!

YankeeWhite
03-10-2003, 02:25 PM
I wonder what a car hauler would charge to get that to Kansas?

crossy
03-19-2003, 12:22 AM
yankee , mapquest says that is 1124 miles from him to you. I THINK? most reasonably priced private haulers charge .50 per mile one way. that would be roughly $600 . I know someone that just had one brought one 3000 miles for $1100. rates may be a little higher right now especially with diesel( most haulers use fuel oil burners ) being so high. It's tough to get away from anywhere on the East Coast without paying heavy tolls also. DAVE

66heavychevy
04-01-2003, 01:17 PM
Do you still have the 64 K-20 rolling chassis. I am in Virginia and would like to slide a 4WD power train under my 66 Camper Special.

Blue'66
04-02-2003, 07:56 PM
Yes, the frame is still for sale. I want it gone soon!