1/2 ton driveshaft to 4 speed trans
I have a 1/2 ton '48ish torque tube style driveshaft/axle that I am putting a 4 speed manual trans of the same vintage in. The enclosed u-joint from the trans is larger(heavier spline) than the 1/2 ton u-joint. What is the best/easiest way to make the connection. I will send pix when available...any ideas?
|
All times are GMT -4. The time now is 04:05 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com