Hooker Headers - Progress Pics
2 Attachment(s)
These are some hooker headers part # 2451-1.
They would work great if the engine was in the I6 position, however in the V8 position they hit the drivers a-arm so I did a little pounding. I didn't have to cut the frame though. I built my own transmission crossmember to run the exhaust through the frame. I still need to blast holes in the trailing arm crossmember and weld in some pipe to run the exhaust right out the back. |
Re: Hooker Headers - Progress Pics
For your own safety ditch the fire starter air cleaner. Nice valve covers.
|
Re: Hooker Headers - Progress Pics
Quote:
do they hang below the frame? my engine is in the I6 opsition, I have doug thorley headers and they hang way below the frame. |
Re: Hooker Headers - Progress Pics
I've done the same thing, I've got 70-81 camaro headers and the I6 engine mounts. My truck is going to be dropped about 4.5" front and 6.5" in the rear, I'm going to love the ground clearance. The hooker headers that for the truck stuck below the frame 4.5" and would only get 3" of ground clearance.
|
Re: Hooker Headers - Progress Pics
I love the custom trans x-member.Everything looks good man
|
Re: Hooker Headers - Progress Pics
3 Attachment(s)
Here's a few more pics. The lowest part of the flange is 2-1/4" below the frame.
|
Re: Hooker Headers - Progress Pics
Thats cool... similar to what I did. I ran some headman s bend header extension and tucked it up even further.
http://i7.photobucket.com/albums/y25...9/100_2045.jpg |
All times are GMT -4. The time now is 12:00 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com