Panhard bar for square body rear in my 65?
I've put a 84 front crossmember with 3" drop spindles in my 65 frame and I want to put the square body rear in back. I've got Jeep Cherokee coils for a 4" drop in back. Won't be a problem to weld the perches on. I'll match the pinion angle of the original rear. What are others doing for a panhard bar?
|
Re: Panhard bar for square body rear in my 65?
While I don't have the same combination that you have, I run an Early Classics track bar from the driver side frame to the passenger side trailing arm.
|
Re: Panhard bar for square body rear in my 65?
Quote:
|
Re: Panhard bar for square body rear in my 65?
You won't want to match the pinion angle of the original rearend. You'll want to set it at what pinion angle the drop requires. Otherwise you'll need to shim it, to be correct later.
|
Re: Panhard bar for square body rear in my 65?
Quote:
|
Re: Panhard bar for square body rear in my 65?
if youre running trailing arms I would order the super trac bar kit from early classic
|
Re: Panhard bar for square body rear in my 65?
I had the super track bar from ECE installed, I switched to the one from POL as it mounts to the pass side trailing arm lower to preclude possibly hitting the frame on that side. My frame is C'd also so it may make a difference.
|
Re: Panhard bar for square body rear in my 65?
it should, my ECE had a 2 locations to possably mount it as well
|
All times are GMT -4. The time now is 11:11 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com