18”-20” Rollers for a Chassis
 

For those of you who have the 14” brake kits on your truck(or cars), what did you use for rollers prior to getting your wheels?

I have a 78’ C10 and will have a new Scott’s frame under it and unfortunately I don’t have any 5 on 4 3/4” wheels for rollers. Should I just pick up some cheap newer model camaro or corvette wheels or are there some steel wheels out there that I can use while the truck is at the shop getting some fab?

Re: 18”-20” Rollers for a Chassis
 

Look for late model Camaro or Cadillac spares.

Re: 18”-20” Rollers for a Chassis
 

couple sheets of 3/4" ply wood works very well. you can then play with overall diameter for setting up the suspension heights

Re: 18”-20” Rollers for a Chassis
 

I bought my wheels and brakes at the same time

Re: 18”-20” Rollers for a Chassis
 

I unfortunately cannot buy my wheels until I get this frame and can mock up and the bed and measure the backspacing for the wheels.

Re: 18”-20” Rollers for a Chassis
 

ply wood....cut the diameter that is desired. then use template card board to cut strips for the width, then you can slide them in and out rather easily.