Replacing cab floor
Is the origonal cab floor welded to the cab supports? I need to replace the drivers side of my floor and am not sure how to do it. Do I need to support the cab some how before I cut out the drivers side of the floor?
Thanks Don Brace MN |
Re: Replacing cab floor
Don Check out my build page. i did the very same work your looking to do. maybe you may find my build usefull. R, mark
|
Re: Replacing cab floor
Hey Don I do that for a living (rustrepair) and I would follow phipp13's pictures Looks like he does great work!
|
Re: Replacing cab floor
Thanks guys for the help. I will give this a shot when the weather improves. Right now it is 5 degrees, snow and windy. Colder tomorrow.Think I will stay in except to go to work.
Don Brace in MN |
Re: Replacing cab floor
I did the ENTIRE floor, at once, with supports... wasn't that bad either.
you'll see that the sheet metal can be seperated from the supports... and it can be done while on the frame. how bad is your floor? |
Re: Replacing cab floor
My floor is only rusted thru on the drivers side near the sill and big hole where the dimmer switch should mount. Thanks for the info.
Don Brace MN |
All times are GMT -4. The time now is 12:07 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com