Ls swap donor...what's needed?
I just recently acquired an 01 2500hd with 6.0 and 4l80 tranny. What all do I need to pull off the donor truck to do the swap. Momma doesn't want this truck sitting in our driveway long(body is very rough)! Please help don't want to get rid of anything I'll need.
|
Re: Ls swap donor...what's needed?
Engine
Engine wiring harness Transmission ECM / PCM Gas Pedal Air Intake if your going to use the stock one Might as well keep the fuse block under the hood Overflow tank Mechanical fan if your going to run that On my swap I'm trying to make it look 100% stock under the hood. Other people have done custom air intakes and electric fans. Also is the truck going to be 4wd or 2wd in the end? Good luck, Nick |
Re: Ls swap donor...what's needed?
2wd in a short bed 67. Do I need cross members, etc?
|
Re: Ls swap donor...what's needed?
Quote:
|
Re: Ls swap donor...what's needed?
If you really want to get everything you can off it it then add throttle cable, cruise control box and cable, rear view mirror and temp sensor/wiring, I used a bunch of the exhaust piping to build my exhaust as well. 7pin trailer wiring, hitch may be able to be used. Saw a post here where someone used the rear brake calipers with a custom bracket. Apparently door molding can be used. Some have used the front bench seat or buckets.
|
Re: Ls swap donor...what's needed?
Quote:
|
Re: Ls swap donor...what's needed?
There's some info in here from when I did my swap. Its a lot to read thru, but it may be some help. Greg
http://67-72chevytrucks.com/vboard/s...d.php?t=585899 |
Re: Ls swap donor...what's needed?
I also used the cats but my donors were low mile. The lead offs might be nice at least to get the exaughst started.
|
All times are GMT -4. The time now is 10:08 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com