sway bar ?
 

i am installing nate's sway bar kit on my 72 with a dropmember and factory 73-87 a arms. my question is the sway bar is close to the rack and pinion setup, it is about 2 inches from touching at ride height and is this safe? it will fully cycle without touching. just gets close at some points when traveling the full cycle.

Re: sway bar ?
 

Yes it is safe... and when you get the other tabs I am making for your factory arms it will give you a little more room. The little angle ones you have in the pics set the bar a little higher.

Re: sway bar ?
 

hey nathan thanks for the response. i was expecting the new tabs to be the same dimensions with a porterbuilt twist. i will hold off drilling any hole until i see the new brackets. thanks again, Daniel.