The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)
-   WTB Parts (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=81)
-   -   CA 1964 c10 292 clutch linkage (https://67-72chevytrucks.com/vboard/showthread.php?t=788594)

Mike_The_Grad 06-14-2019 05:28 PM
1964 c10 292 clutch linkage
 
I am looking for new clutch linkage components. Z-bar, ball studs(engine side, frame side, bellhousing.) I have the rods already, need the swivel though. Plus clips/retainers, felt washers. I have the fork already too.
Any help with all or part or even just pointed to the right source for this stuff would be greatly appreciated. :)

SmirchIs#1 07-14-2019 09:49 AM
Re: 1964 c10 292 clutch linkage
 
Quote:
Originally Posted by Mike_The_Grad (Post 8542417)
I am looking for new clutch linkage components. Z-bar, ball studs(engine side, frame side, bellhousing.) I have the rods already, need the swivel though. Plus clips/retainers, felt washers. I have the fork already too.
Any help with all or part or even just pointed to the right source for this stuff would be greatly appreciated. :)
I have a friend that just converted a 69' 292cu.in. 4X4 truck to a 350.I'll bet at least some of the parts could be the same?No?

Mike_The_Grad 07-19-2019 01:52 AM
Re: 1964 c10 292 clutch linkage
 
I ended up going through a vendor for the parts I needed. Turns out I needed less than I thought. Thanks for the reply though.


All times are GMT -4. The time now is 01:51 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com