Looking for advice
 

I have a 72 C20 and am planning On bagging it but I haven't been able to find many c20 parts mostly c10, will c10 parts fit? If not where would be a good place to look for c20 Parts? Also what steps need to be taken to lay frame, I know I will need to notch the frame in the rear but I'm not sure about the front. Any advice anyone could give me would be greatly appreciated! Thx
Posted via Mobile Device

Re: Looking for advice
 

As far as I know, the trailing arms are the same as well as the control arms, so a simple bag replacing the coils will get you "bagged". As for laying frame, talking with some site vendors will get you there. Porterbuilt is always the 1st that comes to mind, but there are others as well. A few searches will get you the info you need.

Also, welcome to the forum!

Re: Looking for advice
 

Thanks for the info, I will keep all that in mind, I actually just stubbled upon the porterbuilt website through this forum and I really like their products I will definitely be ordering from them in the future. And thanks for the welcome, this is my first forum experience and so far I enjoy it, every thread I've read so far seems to be full of info and no one bad mouths anyone
Posted via Mobile Device