Re: My winter project
 

I needed to free up some space before I start working on the doors. The motor is in and FYI install power steering bracket and trans line clip before you find out as I did and pull motor again.

Re: My winter project
 

Things are going back together. AC box cleaned and the case sealed.

Re: My winter project
 

Working on AC and heating ducting under the dash, there is a lot going on under there.

Re: My winter project
 

We need an update man!

Re: My winter project
 

Casey, your right needed to download phone pictures hope they work. Here is a small update. I completed the engine bay AC stuff and still working on under dash things. I repaired the cut radio hole, I got an aftermarket speaker because that will need to go in first or never get it in, dash pad, middle AC vent and ducting work my way down and out. I had a paint shop mix GM 521 to factory spec. and put in spray can application I'll post when I get the dash painted.

7D2N
sorry for sideways pics can some one helpme turn them.

Re: My winter project
 

Here you go

Re: My winter project
 

Thank You

Re: My winter project
 

Small update: I rattle can sprayed my dash with the 521 GM paint I had the shop mix and I think it worked out fine.

7D2N

Re: My winter project
 

Dash cluster work.

Re: My winter project
 

I just read this whole thing and couldn’t stop until I read it all. Nice work.

Re: My winter project
 

Nice work....how hard is it too pull off the needles for the gauges

Re: My winter project
 

Thanks guys, I couldn't have done half of this without the information on the board.
I didnt remove the needles, if you noticed the aluminum foil in the photo I cut small slots and slid it under the needles and pressed in place and used a brush on reflective needle paint.

Re: My winter project
 

Great idea, thanks for sharing I've been wanting to do that for a while and didn't want to break it
Is the paint available online, looks like a good match

Re: My winter project
 

Yes, the paint is available online and worked great. The bottle I have has plenty more if you need it.
7D2N

Re: My winter project
 

I completed a few things on and under the dash, kick panels vents rebuilt, all ductwork replaced and GM radio installed.

Re: My winter project
 

I'm really close for the gauge cluster going in.

Re: My winter project
 

Craig,

Good to see that you are making great progress. Looks great!

Jothan

Re: My winter project
 

Thanks Jothan, Thanks again with the parts you helped me out with. I did finish up the dash area so I'll start on the doors.

Re: My winter project
 

That looks so nice. I want a blazer now.

Re: My winter project
 

Thanks,

Re: My winter project
 

Moving to the doors and I have some things to fix.

Re: My winter project
 

I had some sandblasting done on my doors and fenders, does anyone know how should I prep the surfaces until I can repair?
Thanks.
7D2N

Re: My winter project
 

Started working on the doors and they need some patches. Any tips or advice on welding this together, butt weld, lap weld?
Thanks 7D2N

Re: My winter project
 

I'd butt weld it. Nice work so far.

Good luck, Rg

Re: My winter project
 

I'm fitting the patch panels on the doors, checking the fit and alinement before I cut for welding.