The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)
-   Electrical (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=64)
-   -   Yet Another Power Door Lock Question (https://67-72chevytrucks.com/vboard/showthread.php?t=764253)

trukman1 05-22-2018 08:32 AM

Yet Another Power Door Lock Question
 
Door switch on my '88 K5 operates the RH side just fine but not the LH side. RH switch does the same thing.

I've checked the switch, the actuator solenoid, there is power to the switch. Any ideas as to what I can check next?

I'm assuming since there is power to the switch the relay should be okay. Am I off on this assumption? (And if so, can the relays still be found?)

Thanks for your help.

trukman1

speedygonzales 05-22-2018 10:11 AM

Re: Yet Another Power Door Lock Question
 
You say you have power to the switch in question. Does it have power out when switched?

Wgesnerjr 05-22-2018 02:28 PM

Re: Yet Another Power Door Lock Question
 
Might be a bad connection at the actuator. Had a devil of a time with my install. Must have removed the wires, cleaned and bent contacts two or three times. Would work for a while then quit.

Finally got a good, clean connection and made sure the plug had a good amount of di-electric grease to prevent corrosion. Been working for over a month now.

Also, the actuator needs a good ground to the door shell.

trukman1 05-23-2018 09:51 AM

Re: Yet Another Power Door Lock Question
 
Quote:

Originally Posted by speedygonzales (Post 8265989)
You say you have power to the switch in question. Does it have power out when switched?

speedygozales,

I have power to the switch but not to the solenoid. Tested solenoid on battery and it seems to work fine.

Thanks, trukman1

trukman1 05-23-2018 09:56 AM

Re: Yet Another Power Door Lock Question
 
Quote:

Originally Posted by Wgesnerjr (Post 8266136)
Might be a bad connection at the actuator. Had a devil of a time with my install. Must have removed the wires, cleaned and bent contacts two or three times. Would work for a while then quit.

Finally got a good, clean connection and made sure the plug had a good amount of di-electric grease to prevent corrosion. Been working for over a month now.

Also, the actuator needs a good ground to the door shell.

The LH switch will operate the RH door lock but not the LH. I'm thinking I've got a ground issue somewhere or else a relay. I don't know how the relay operates and haven't even been able to find it even though I've read where it's "supposed" to be. Haven't found it yet. I'll keep looking and also try to find out if the relay can cause this problem. Since the RH side works I'm doubtful it's the relay but won't know for sure till I find and test it. Thanks.


All times are GMT -4. The time now is 10:53 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com