The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)
-   The 1947 - 1959 Chevrolet & GMC Pickups Message Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=13)
-   -   Sub frame motor mounts (https://67-72chevytrucks.com/vboard/showthread.php?t=326162)

jjjmm56 01-29-2009 05:00 PM
Sub frame motor mounts
 
Any one that has done a camaro sub frame swap , is there a right and left hand motor mount for a SB. My motor sits about 3\4" off. The drivers side is more foward . Any ideas?

jjjmm56 01-29-2009 06:20 PM
Re: Sub frame motor mounts
 
This sub frame is grafted to a 56 frame

56chevy1300 01-29-2009 06:41 PM
Re: Sub frame motor mounts
 
Most likely because the Camaro crossmember is not symmetrical.

my67chevytruck 01-30-2009 12:02 AM
Re: Sub frame motor mounts
 
have to agree. i have a camaro subframe, and my engine is sitting square...

Robertw 02-03-2009 12:08 PM
Re: Sub frame motor mounts
 
or the sub could have been in a collision some time

jjjmm56 02-03-2009 06:03 PM
Re: Sub frame motor mounts
 
Found out everything is good, I didn't think about the pass side cyl head being 3/4" offset. I did then frame swap 20 yrs ago when there wasn't a lot of info on it. But measured everything and it's all good!


All times are GMT -4. The time now is 02:37 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com