I Need Water Pump Torque Values?
I'm in need of the 6ea mount bolts and the idle pulley nuts on an all aluminum 5.3L block RPO LO8 2010 Colorado.
Tnkx. |
Re: I Need Water Pump Torque Values?
For the water pump: First pass is 11 ft/lbs. Second pass is 22 ft/lbs.
The 3 bolts for the belt tensioner should be 37 ft/lbs. |
Re: I Need Water Pump Torque Values?
Are you looking for torque specs or are u looking to buy the bolts and nuts?
|
Re: I Need Water Pump Torque Values?
Title says torque values?
If you need the bolds, get them at the dealer, hardware store bolts look out of place. |
Re: I Need Water Pump Torque Values?
Thanks 95 S Trucker that's what I was looking for.
In the aviation profession a fastener Torque is known as or referred to as a Value not a Spec. Are the water pump mount bolts on the LS engines known for going bad? I've had this truck 4 yr's and it's the original pump and this is the first thing that I've had to replace on it other than plugs n wires. I don't know if the hardware is good or bad as I am still driving it I plan to do the water pump this weekend. It's leaking out the weep hole after only 267.000 miles. |
Re: I Need Water Pump Torque Values?
Quote:
|
Re: I Need Water Pump Torque Values?
Youre first sentence says you are in need of 6 bolts and nuts for the idler. It was a little unclear on this side of the screen.
The bolts don't go bad. |
Re: I Need Water Pump Torque Values?
Quote:
Thank you both for this info. |
Re: I Need Water Pump Torque Values?
Just replaced the water pump on my LQ4 in my '06 Silverado. Reused the original bolts... no prob.
Gary |
All times are GMT -4. The time now is 02:36 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com