Turbo 350 kickdown cable adjustment....can't find the link
 

Anybody save the post that had the proper procedure to adjust Turbo 350 kickdown cable?
SC

I don't have the link but I know the answer. Where the cable comes thru the bracket there are little clips on the backside of the bracket. Pop these loose with a screwdriver,then the cable will be loose in the braket. Push the gas pedal all the way to the floor,and take your finger and pop the clips back in where they were. You are all done.

------------------
72 GMC Sierra SWB almost finished---- 84 Softail
Olive Branch MS



[This message has been edited by tom hand (edited May 13, 2002).]

Thanks, Tom, but it's an aftermarket bracket - no clips, just have the ability to loosen screws on the bracket and slide the part holding the cable backward or forward.
SC

Is it an aftermarket cable? The clips I speak of are part of the cable.

------------------
72 GMC Sierra SWB almost finished---- 84 Softail
Olive Branch MS

I was wondering if that's what you meant when you said bracket.
No, it's a factory cable, and I'm going to try your method when my buddy gets over here later.
SC