The 1947 - Present Chevrolet & GMC Truck Message Board Network

The 1947 - Present Chevrolet & GMC Truck Message Board Network (https://67-72chevytrucks.com/vboard/index.php)
-   The 1973 - 1987 Chevrolet & GMC Squarebody Pickups Message Board (https://67-72chevytrucks.com/vboard/forumdisplay.php?f=4)
-   -   Intake Manifold Oil Leak (https://67-72chevytrucks.com/vboard/showthread.php?t=849628)

44SAA 12-31-2023 11:06 PM

Intake Manifold Oil Leak
 
I have oil pooling on both sides of my manifold between the carb and valve covers. The oil is not escaping from the top of the valve covers. Is it possible this oil is escaping from the 2 manifold bolts? I tried to snug the bolts with a wrench but the carb makes wrench access a challenge. Thank you

Getter-Done 12-31-2023 11:42 PM

Re: Intake Manifold Oil Leak
 
The threads on those bolts are Thru holes.

You can try put the silicone in the link below,
on the threads of the 4 bolts.
Pull them out one at a time and clean and coat them with silicone.

If that don't work then it's intake gasket time.

Link: https://www.amazon.com/Permatex-8187...0002UEOPA?th=1

Dead Parrot 01-01-2024 02:14 AM

Re: Intake Manifold Oil Leak
 
Also make sure your PCV valve and air filter are working. A malfunctioning PCV system can cause pressure buildup in the crankcase and might lead to oil coming out where it normally won't.

Sometimes those bolts can be tightened with thin wall sockets and a u-joint. But 2nd the idea of some kind of sealant first.

44SAA 01-01-2024 02:49 PM

Re: Intake Manifold Oil Leak
 
Removed manifold bolts, cleaned and applied copper Permatex. FYI- challenging to do this with carb in the way, much less torque them to spec…..

Question- I just removed the AC bracket that comes off the manifold. Couldn’t help but notice both bolts were dripping w oil. Dipped a q-tip in the bolt holes and there was lots of oil in them.

1) are these AC mounting bracket holes going all the way into the manifold?
2) assuming I’m safe applying permatex to these bolts as well?

Thank you

cadillac_al 01-01-2024 02:50 PM

Re: Intake Manifold Oil Leak
 
Yes, those bolts are supposed to be sealed. I think Permatex #2 works much better than silicone in this application.

Getter-Done 01-01-2024 03:14 PM

Re: Intake Manifold Oil Leak
 
Bolts like the ones in the links will give you better access and you can tighten those easier.
These are just for Example.
Most of these are short and are only used without brackets.

Just make sure you order some that with be long enough for your Brackets

Link: https://www.ebay.com/itm/36333811508...2057b23e693429

Link: https://www.ebay.com/itm/11598377356...f8bf59c61bd5fe


All times are GMT -4. The time now is 03:38 PM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com