Pictures of my rear end
2 Attachment(s)
Okay, I'm not going Harvey Weinstein on you, I just need help identifying this pinion yoke so I can get u-joints and make a driveshaft. It's a GM 12-bolt but the pinion yoke seems non-standard. Those cups are 1-1/16" but that's supposed to be an outside clip u-joint but there are no retaining tabs. My local driveline guy suspects someone ground off the retaining tabs. I'm much more familiar with Ford rear ends; any classic Chevy guys help me out?
|
Re: Pictures of my rear end
whewww ....that's a relief....I didn't know where you were going with this...haha
|
Re: Pictures of my rear end
Quote:
. |
Re: Pictures of my rear end
This rear end does NOT look like the original one in my '55 sedan.
|
Re: Pictures of my rear end
1 Attachment(s)
Here's a better pic with dirt cleaned off. It appears to have the tabs ground away.
|
Re: Pictures of my rear end
yeah.....I guess I did didn't I.....haha
|
Re: Pictures of my rear end
Tabs are ground off. Get another yoke.
|
Re: Pictures of my rear end
Quote:
|
Re: Pictures of my rear end
Quote:
|
Re: Pictures of my rear end
Quote:
|
Re: Pictures of my rear end
Quote:
|
Re: Pictures of my rear end
Would an inner c-clip style u joint help him?
|
Re: Pictures of my rear end
Quote:
Quote:
|
Re: Pictures of my rear end
Here's a list of U-joints from Randy's Looks like there is a bunch of different styles and spreads. Assuming that it's a 1310, 1330 would be different yet.
https://www.ringpinion.com/b2c/Parts...ID=5&CatID=104 |
Re: Pictures of my rear end
1 Attachment(s)
When you save and expend the last photo that is super clear you can see what's left of the tab on the right hand side where I circled it. If you were desperate you could build it up with weld and then take a Dremel tool or die grinder to it but that is a bit chancy. The price of a new yoke is probably inexpensive insurance against problems or vibrations.
|
Re: Pictures of my rear end
Quote:
|
Re: Pictures of my rear end
Here's a Craigslist listing of a rear end that looks a little like yours. Even has the square bosses near the axle tubes.
https://cincinnati.craigslist.org/pt...474420966.html Hope this helps in identifying your yoke. |
Re: Pictures of my rear end
Quote:
The way my luck runs if I had tried to run it that way the U joint cup would have slipped sideways and I'd have the driveshaft shaking and baking as I went down the road. |
All times are GMT -4. The time now is 01:27 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com