|
floor replacement 82 k5 2wd
5 Attachment(s)
my son ordered floor pans for his blazer for me to install. Very thin material . seems on the left hand rear panel they added the hole for the right side. seems somebody can't read a print. previous owner fiberglassed a real rotten floor. over all i would not purchase lmc pans again . the pans are a real challenge to weld. I bought flat bar and plate 1/8 " to fill in the center and replace side plates .
|
Re: floor replacement 82 k5 2wd
1 Attachment(s)
I just finished one side of mine and it wasn,t as easy as it looks.I too had to fab my own stuff
|
Re: floor replacement 82 k5 2wd
4 Attachment(s)
I had to re fab new pieces on both rear seatbelt panels. I also made new mounting support on the drivers side . The only way i could get the panel in was to cut the support .Thinking it would have turned out better if i made my own . The panels are too thin and flimsy . rocker tops get 1" x1/8 flat bar backup strips . Tig weld them. hard wire the rest.
|
Re: floor replacement 82 k5 2wd
2 Attachment(s)
welding show now. then reassemble
|
| All times are GMT -4. The time now is 11:32 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com