New Master Cylinder and Bleeder
I replaced my original master cylinder with a new one and started bleeding the valve on top. My single line connects to the side and I plugged the very front hole with a fitting. My other C10 is exactly like this, however, my top bleeder screw is just spewing out fluid through the hole anytime I hit the brakes.... What am I doing wrong?
|
Re: New Master Cylinder and Bleeder
It sounds like the bleeder is not seated tightly or there is something in the seat. Pull the bleeder, inspect and clean if necessary. Then tighten again and see what happens.
|
All times are GMT -4. The time now is 12:39 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com