A little support for my 72 driveshaft support bearing
4 Attachment(s)
I have seen where these carrier bearing mounts break off on this style so I added a little support. This is a fernco rubber pipe hub I got at lowes. I cut it at 6 1/2 inches, I should have done 7 1/2. I think I will get another one. The ridges on the side hold it in nice and tight. I sprayed it with WD40 and tapped it in from the transmission side.
|
Re: A little support for my 72 driveshaft support bearing
Nifty! Let us know if you can feel and additional vibrations or sounds and how it turns out in time. Looks like a great idea to me.;)
|
Re: A little support for my 72 driveshaft support bearing
Not sure that will prevent the metal from breaking however I think having one in the tool box might get you home if the bearing housing does break.
I recently replaced my hanger bearing, not due to the metal breaking, the rubber was worn out and shaft was scraping on the housing. Bill |
Re: A little support for my 72 driveshaft support bearing
I like it, I like it a lot...I'm wondering if a full radiused piece with a single slit to clear the stem at the top? Zip-tie and it should help dampen and keep the bearing stem located and held in position..? ;)
|
Re: A little support for my 72 driveshaft support bearing
Quote:
|
Re: A little support for my 72 driveshaft support bearing
Waste of time
|
Re: A little support for my 72 driveshaft support bearing
Quote:
|
Re: A little support for my 72 driveshaft support bearing
It wont stay in.......... And its not 100 percent contact.
|
All times are GMT -4. The time now is 06:41 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.
Copyright 1997-2022 67-72chevytrucks.com