[valleycustom]

Well after many hours of thinking I decided to redo the rear canti setup. It's going to look the same but have bigger components. The new verision isn't going to use bushings, but it's going to run wheel bearings from a mustang II rotor. With this new setup it will eaiser to get replacement bearings rather than making bushings from stock. Here are some pictures of the old setup and the new setup I'm making right now and some picture showing what I need to do to get this stuff to work. The first picture shows what the stock looks like when I start on the right and what it looks like when I'm finished on the left. The last picture you can see the difference between the old and the new.