|
Re: Custom Chassis with canti setup
Quote:
|
Originally Posted by low4life1
Somebody correct me if I'm wrong, but there shouldnt be a problem with the rear seal because the carrier bearing takes all the stress off of that joint. The driveshaft near the tranny shouldnt move in or out or anything. it just rotates so there shouldnt be any excessive wear no matter what height or how much playing is done.
|
Your right. We shouldn't have a issue with the rear seal. Even so if the seal did go out the system is going to be ceramic coated. This will cut the temp of the sytem down so much I'll be able to hold the pipes while the truck is driving down the street if I really wanted to, but that wouldn't be a good idea. LOL I thought the same thing but I really didn't have any another options. Once we decided to get the system jet coated I felt that there would be an issue with heat.
__________________
Please become a site supporting vendor to advertise a business in your signature. you can do so here
Last edited by valleycustom; 01-31-2006 at 12:49 PM.
|