Quote:
Originally Posted by c10chevy69
I am looking at buying a welder for sheetmetal and lightweight fabrication. My problem is that I do not have a garage to weld in. Does anyone have any suggestions in this situation. All of the bodywork will have to be done outside in the wind.
|
Say,if you get a small mig you can weld with a fluxcore wire that has the flux inside and it takes no gas and you can use it in the wind.But the best welds will be a welder with gas.I have 3 lincoln welders myself but at work we have a little 110volt hobart all you have to do is reverse the leads to use fluxcore wire.