The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Another Stupid 4x4 Question

*trkklr77* · 11-13-2006, 02:14 PM

its not just the 71-72 axles.

all 10b and d44 knuckles are the same.

not all the spindles are the same, but they all work on all knuckles.

any 3/4t setup from 71-91 will fit.

the rotor is bigger, the backing plate is bigger [AND MANDATORY!!!], the spinlde is bigger than the d44 1/2t but is the same as all 10b spindles.

if you have a complete axle that you think is ready to run, why strip it and yours apart, it will only take about half the time to swap out the intire axle.

11-13-2006, 02:14 PM	#5
trkklr77 Account Suspended Join Date: Aug 2006 Location: vacaville ca, because it as far from indy as i can be Posts: 777	Re: Another Stupid 4x4 Question - Front Spindle 3/4 vs. 1/2??? its not just the 71-72 axles. all 10b and d44 knuckles are the same. not all the spindles are the same, but they all work on all knuckles. any 3/4t setup from 71-91 will fit. the rotor is bigger, the backing plate is bigger [AND MANDATORY!!!], the spinlde is bigger than the d44 1/2t but is the same as all 10b spindles. if you have a complete axle that you think is ready to run, why strip it and yours apart, it will only take about half the time to swap out the intire axle.