[PICKMUP]

I give up...again! There may not be any more of these, at this price, anyway.
The manufacturer says they can't do another production run at this price and the buyer for the distributor will not pay more...at this time.
Here is what we are doing to use the remaining RH manifolds that are still available.
Remove the 5/16 tube by punching it out or drilling both ends and then just tapping it for 1/8" pipe thread allen plug...Like they do on the air pump holes on all aftermarket ramhorns.
...OR you can weld up the holes. I still like to countersink the allen plugs about 1/4" so there is a bottom in the hole to weld to.
These manifolds are the same price as the other side. $130shipped w/gaskets & studs. I can supply 2.5 mandrel bent pipes for $50 pr (these will not have flanged ends--just pipes). See the first pic.
I won't have time to do any more of the fully prepped sets, so it is a "Do It Yourself" project from here on.
There are a few sets left, so post on here if you would like to order some of these.