The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - 67 gmc-project ball to the walls

mcc-bri · 02-08-2008, 03:33 PM

I have started putting my 327 back together today. So far i have washed and blown the block out, intalled main bearings, checked clearances and the crank and rear main seal are in and ready to go. I will start on my heads tommorow and see how far i get. Then friday i will finish up what i can on my heads and then move on to the pistons and rods and filing my rings to the right end gap and then doing the rod bearings. Ill post pics later of my progresse.

02-08-2008, 03:33 PM	#36
mcc-bri Registered User Join Date: May 2007 Location: Winnipeg, Manitoba Posts: 186	Re: 67 gmc-project ball to the walls I have started putting my 327 back together today. So far i have washed and blown the block out, intalled main bearings, checked clearances and the crank and rear main seal are in and ready to go. I will start on my heads tommorow and see how far i get. Then friday i will finish up what i can on my heads and then move on to the pistons and rods and filing my rings to the right end gap and then doing the rod bearings. Ill post pics later of my progresse. Last edited by mcc-bri; 02-08-2008 at 03:34 PM.