|
Re: 67 gmc-project ball to the walls
Friday i finished assembly of the heads which took me a couple hours since i shimmed every spring to the right height. Today i was lucky to get into the shop and was able to install the cam, gear drive, timing cover and i go all my rings to the right end gap and have started on putting my bearings on my rods. Hopfully monday during class i can start dropping pistons into the block.
here is one pic of the cam in and gear drive on and the first peice of my 2 peice timing cover(i later found out that i put that first peice on backwards and flipped it around before anything had dried in place.
|