The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Joined the Short Wheelbase Club *69 Tahoe Project*

Frizzle Fry · 06-27-2008, 06:17 PM

Well, I took a chance on a local shop hoping the bends wouldn't be too bad

They're not usable IMO (mandrel is the only way to go). So there's $60 gone and a lesson learned.

I contacted Flowmaster directly today. They said they would have to make them for me at the end of a 3" run, but got back to me with a quote of $24.44 each. I said I'll take em

This, and some other distractions including the 64, has derailed my progress on Tubby for a couple weeks. So with this new wind in my sails I'm headed out to work on the passenger side now

I should have both sides hung to the mufflers by the time I get these.

06-27-2008, 06:17 PM	#815
Frizzle Fry Registered User Join Date: Aug 2005 Location: Hillsboro Oregon Posts: 6,449	Re: Joined the Short Wheelbase Club 69 Tahoe Project Well, I took a chance on a local shop hoping the bends wouldn't be too bad They're not usable IMO (mandrel is the only way to go). So there's $60 gone and a lesson learned. I contacted Flowmaster directly today. They said they would have to make them for me at the end of a 3" run, but got back to me with a quote of $24.44 each. I said I'll take em This, and some other distractions including the 64, has derailed my progress on Tubby for a couple weeks. So with this new wind in my sails I'm headed out to work on the passenger side now I should have both sides hung to the mufflers by the time I get these. Last edited by Frizzle Fry; 06-28-2008 at 12:01 AM.