The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Bazooka · 08-15-2008, 10:15 PM

Got the wheels and tires mounted today.. Haven't orderd the center caps yet cause I wanted to order them at the same time I order my drop spindles (save shipping $) and I needed to measure my rotors while I had the wheels off. I am going to be using the DJM 3" spindles. My rotors are the 1.25" units so I can order the cheaper set.. They are $50 cheaper then the ones for the 1.0" rotors..

Whoever lowered this truck just cut the springs like a mad man with stock spindles and there is huge camber and a very bouncy ride.. thats all going to be fixed..

Next on the agenda is to get this puppy laying on the pavement..

I think it will look much better when I get the caps on there and sitting level at ride height..

08-15-2008, 10:15 PM	#21
Bazooka Keepin it old school Join Date: Jul 2008 Location: Ca Posts: 672	Re: Bazooka's 63 build thread. Got the wheels and tires mounted today.. Haven't orderd the center caps yet cause I wanted to order them at the same time I order my drop spindles (save shipping $) and I needed to measure my rotors while I had the wheels off. I am going to be using the DJM 3" spindles. My rotors are the 1.25" units so I can order the cheaper set.. They are $50 cheaper then the ones for the 1.0" rotors.. Whoever lowered this truck just cut the springs like a mad man with stock spindles and there is huge camber and a very bouncy ride.. thats all going to be fixed.. Next on the agenda is to get this puppy laying on the pavement.. I think it will look much better when I get the caps on there and sitting level at ride height.. Last edited by Bazooka; 09-22-2008 at 08:38 PM.