[brossow]

Finally got my garage wired for the oven today and tried my hand at powdercoating some stuff. Did the pair of spindles and they came out pretty good (they were rough sand cast to start with and I did absolutely no smoothing or filling so I didn't expect much; the pic below is after the first coat -- they got two coats apiece) as well as some tie rod sleeves that turned out beautifully. Can't wait to try some more stuff -- have to look around for something to coat!

FedEx dropped off a package from Eastwood this morning, so I was also able to finish painting the K-member (wanted to use spray Chassis Black on the top; did the bottom with a brush) as well.

Now I have to go back out and try to cram all the stuff back into the garage that I took out to make room for the stove. That's gonna be fun. I think my Fiero's new rims and tires are going to the basement instead of back in the garage.