The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

jjjmm56 · 02-03-2009, 06:03 PM

Found out everything is good, I didn't think about the pass side cyl head being 3/4" offset. I did then frame swap 20 yrs ago when there wasn't a lot of info on it. But measured everything and it's all good!

02-03-2009, 06:03 PM	#6
jjjmm56 Registered User Join Date: Jan 2009 Location: kissimmee Florida Posts: 494	Re: Sub frame motor mounts Found out everything is good, I didn't think about the pass side cyl head being 3/4" offset. I did then frame swap 20 yrs ago when there wasn't a lot of info on it. But measured everything and it's all good!