The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

71swb4x4 · 03-18-2009, 10:39 PM

I had class again, so I haven't worked on it. My little break was between two classes.
It runs fine right now, I just want to move it one tooth so I can adjust a little more if needed. I have not hooked up a vacuum gauge to check the timing, so I need to do that too.
I will probably move it one tooth tomorrow and set the timing by feel. Then I need to get it weighed so I can register it. I sort of haven't registered it yet, so no license plates yet.
The vacuum gauge is at my dad's so I might go get it this weekend. Maybe I should just buy my own vacuum gauge.

03-18-2009, 10:39 PM	#35
71swb4x4 Senior Member Join Date: Nov 2003 Location: Brookings, SD Posts: 10,497	Re: 1967 C30 dump truck I had class again, so I haven't worked on it. My little break was between two classes. It runs fine right now, I just want to move it one tooth so I can adjust a little more if needed. I have not hooked up a vacuum gauge to check the timing, so I need to do that too. I will probably move it one tooth tomorrow and set the timing by feel. Then I need to get it weighed so I can register it. I sort of haven't registered it yet, so no license plates yet. The vacuum gauge is at my dad's so I might go get it this weekend. Maybe I should just buy my own vacuum gauge. __________________ Some people are like slinkies, they aren't good for anything, but you can't help but smile when you see one tumble down the stairs.