Re: Tbi swap build thread
Gas to TB is good. If injectors are not spraying during cranking there are couple of possible problems.
1) Disconnect both injectors from harness. Check the +B (red and green???) injector wire - it should be +12 when ignition key is on and during cranking.
2) If you have +12V on red wire reconnect injectors, get a +12 volt low current test light (or fast DVM). Probe both injector pins (red and green and red and blue - colors are typical, but maybe different) - red should be a steady +12, while the other side should pulse on-off-on during cranking. No pulse indicates that's ECM is not pulling line low. There are couple of possibilities.
//RF
__________________
"The Beast"
1975 Chevrolet C20 longbed
350/ 700R4! with 3inch body lift
Dual Flowmasters Super 40's!
TBI retrofit completed (2007-07-29)
New 383CID (+030) 08-304-8 9.5:1CR x36,005 (2012-12-17)
|