Re: Got some new wheels: Boss 338's in 20x10 and 20x8.5
Quote:
Originally Posted by Hickup pickup
I will be puting a nitrogen infused intercooler to disipate the generated heat transduced through a ridgid Kenuter valve perpetuated into a Flux capacitor.thus cooling the center cap.
I think the PLASTIC cap would melt long before the silicone.
|
I'm sorry..... I don't recall saying anything about melting . My logic was more on the heat cycles, bearing grease, & road grime that's typically associated w/the spindle hub area.
These are nice looking wheels. Not nice enough to jump through the hoops required to run them w/1/2 ton truck rotors IMO.
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
Last edited by SCOTI; 07-10-2009 at 04:14 PM.
|