The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

dv8customs · 08-10-2009, 10:56 PM

Got the bed off today and started unbolting the cab. Got the rear two bolts out but after a couple of turns both front bolts started spinning. From what I can tell my only option is to cut a hole in the floor to get the nut. Hope to get the cab off before the end of the week and start on the frame work this weekend.

08-10-2009, 10:56 PM	#152
dv8customs Registered User Join Date: Jan 2009 Location: East Texas Posts: 1,047	Re: Project '86 Got the bed off today and started unbolting the cab. Got the rear two bolts out but after a couple of turns both front bolts started spinning. From what I can tell my only option is to cut a hole in the floor to get the nut. Hope to get the cab off before the end of the week and start on the frame work this weekend.