Finally getting back on it. Decided to work on the hood. I cut the problem areas out so the sand blaster can get to the inside of the corners.
The right corner was the worst of the two sides.
I'm holding a chunk of filler that was packed in the corner.
This is the Left side.
It only had pin holes. I will clean the rust and weld the holds and reinstall.
I'm going to use extra cowl side panels to cut out patches. The contour is already there. Since I couldn't give them away I figured why not put them to good use. They can also be used to repair door check strap damage.
I have an extra hood that isn't any good on the outside, but has a good inner structure. I'll cut patches out of it to repair the bad areas.