Here is the brace and floor going in. The thought here was to be careful to make sure the brace was at the correct angle to attach to the "A" pillar. I needed to trim the brace a little on the small end to make it fit (1/4"). But all went into place after that. I was a little worried that the "A" pillar patch was in too far causing this but it appeared to be strait when I used a strait edge next to it.
The floor is in now. I will post pics of that later.
__________________
69 CST-10 SWB (disguised as a 67) 383/700r4
Jezebel
Jezebel 3.0 NEW!!!
2020 GMC 3500 Denali Duramax
2016 Harley Street Glide CVO
Roll Tide!