The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

skoffice · 02-07-2010, 02:20 PM

Oh and motor mounts I just made the adapter plates that are the triangular shaped ones. I saw a thread somewhere on here that shows you how to do it. Just used some 3/16" plate. The piece where the motor mount actually bolts to the frame and crossmember, where the single large bolt goes through, I had to elongate the hole upward about 5/8" for it to fit, since this engine sits a tad bit wider with this configuration.

02-07-2010, 02:20 PM	#10
skoffice Registered User Join Date: Apr 2007 Location: Elk Grove, CA Posts: 375	Re: I figure it's about that time.. Oh and motor mounts I just made the adapter plates that are the triangular shaped ones. I saw a thread somewhere on here that shows you how to do it. Just used some 3/16" plate. The piece where the motor mount actually bolts to the frame and crossmember, where the single large bolt goes through, I had to elongate the hole upward about 5/8" for it to fit, since this engine sits a tad bit wider with this configuration. __________________ 1964 C10 Shortened Shortbed Cammed LQ9 P&P 1967 C10 Trophy Truck BB 438 (soon to be worked on again)