The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

raycow · 05-26-2010, 06:28 PM

Since the TH350 didn't start until 1969, all the factory installs will have a Monojet instead of the Model B carb like you have. I don't think the linkage is much different between the two carbs though, so look for a donor vehicle in the 69-74 range. The engine changed to an integral manifold around 1975, and I don't know if the linkage on those is the same.

I don't think you are very likely to find an aftermarket cable bracket for the 6 cylinder because of less rodding interest in those engines as compared with the V-8s. However, it couldn't hurt to ask the inline specialty vendors like Patrick's or Langdon's

Ray

05-26-2010, 06:28 PM	#5
raycow Registered User Join Date: Mar 2003 Location: San Francisco, CA USA Posts: 2,454	Re: hooking up a kick down cable Since the TH350 didn't start until 1969, all the factory installs will have a Monojet instead of the Model B carb like you have. I don't think the linkage is much different between the two carbs though, so look for a donor vehicle in the 69-74 range. The engine changed to an integral manifold around 1975, and I don't know if the linkage on those is the same. I don't think you are very likely to find an aftermarket cable bracket for the 6 cylinder because of less rodding interest in those engines as compared with the V-8s. However, it couldn't hurt to ask the inline specialty vendors like Patrick's or Langdon's Ray Last edited by raycow; 05-26-2010 at 06:42 PM.