The old body is off, but not without a fight.
Seems like the supports underneath just were not goinf to hold that firewall up, but we went up a little more just to see. We stopped here because the firewall was pushing against the distributor.
So we got the sawzall out and split it in two. The bed came off easy enough.
Would make a cool little low rider trailer huh?
The firewall was a struggle for 2 people. We had to flip it towards the back to get it over the transfer case shifter. This was the only way I could think of to lift it off.
That left us here.
The bed was covered in a sheet of aluminum and I pulled that off to get the original rubber pads out from under it. The floor was a bit rusted.
