The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

*mrhino* · 11-23-2010, 11:09 AM

After the Cab and bed went back on. (sorry no Pictures of that.) it was time to start Hooking up the fuel fill.

This is a shot of the fuel fill hose going over the frame

I cut a notch in the rear bed support channel so the fuel fill hose and vent hose could make there way to the stake pocket in the bed

once in the channel, it is not visible from the underside. unless you look straight up into it.

I had to make the hole in the inside of the stake pocket behind the back up light a little bigger. Then slipped the hose onto the Marine fuel fill, and tightened with a couple hose clamps.

Pushed it into the the stake pocket.

Tightened it with the 4 screws and closed the lid.

11-23-2010, 11:09 AM	#133
mrhino Account Suspended Join Date: Aug 2007 Location: USA Posts: 1,223	Re: Silver Dollar After the Cab and bed went back on. (sorry no Pictures of that.) it was time to start Hooking up the fuel fill. This is a shot of the fuel fill hose going over the frame I cut a notch in the rear bed support channel so the fuel fill hose and vent hose could make there way to the stake pocket in the bed once in the channel, it is not visible from the underside. unless you look straight up into it. I had to make the hole in the inside of the stake pocket behind the back up light a little bigger. Then slipped the hose onto the Marine fuel fill, and tightened with a couple hose clamps. Pushed it into the the stake pocket. Tightened it with the 4 screws and closed the lid. Last edited by mrhino; 11-23-2010 at 11:12 AM.