Quote:
Originally Posted by 8door
heymoe:That is a great looking drive line. Was that your idea on pipe routing ?
The starter appears smaller than stock ?
|
I fit the exhaust in place in about 3 hours. The tricky part is the combination of roll on the 90 deg. elbow coming off of the manifold. The 90 is rolled away from the block and starter but also rolled down at an angle to match the contour of the frame. Then I had to square everything back up with a miter right just past the linkage on the transmission. The cross pipe was a pain because when I built it I thought I had enough clearance for the drive shaft but needed to be a bit lower due to the articulation when you play with the air ride.
The starter is stock. I tried a mini first and it would not fit due to the mounting block.
Thanks for the comments!
Quote:
Originally Posted by theCheyenneShop
This thing looks great! Do you have any more pics (close up) of the manifolds and there closeness?
|
Thanks so much! I will try to get some more when I get it back. I sent it over to a buddy's house to wire everything. I'm working 70+ hours and don't have much free time right now.