The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Jonboy · 04-26-2011, 03:43 PM

Check the classifieds here, too. By becoming a supporting member, you can post "want to buy" ads as well.

I would pull the extension housing off of your trans and have a look. If you can run a gear and a speedo cable, the 2PRS will get you all set, without a DRAC. I know you can just disconnect the AIR on an early TPI engine, so I am sure TBI is similar. It will not set a code.

04-26-2011, 03:43 PM	#15
Jonboy Slots go on anything! Join Date: May 2003 Location: Richardson, TX Posts: 5,957	Re: Tbi swap build thread Check the classifieds here, too. By becoming a supporting member, you can post "want to buy" ads as well. I would pull the extension housing off of your trans and have a look. If you can run a gear and a speedo cable, the 2PRS will get you all set, without a DRAC. I know you can just disconnect the AIR on an early TPI engine, so I am sure TBI is similar. It will not set a code. __________________ 1974 Jimmy- 5.3/4L80e/NP241