Ahhhhhh wiring!
Started fabbing a bracket/mount for the dbw pedal. The heavy plate might be a bit much, but I wanted to make sure if I "pedal to the medal"...the pedal would stay mount.
Still need to do some test fitting before I clean up the corners and paint it up.
The po was a short little bastard I guess, because the floor shifter location jammed the handle right up into my knee. Rather than pay B&M for a new shifter (since mine works fine), I decided to see if I could mod mine up, plus it allows me to make a larger "hot rod" shifter. Its not done yet, but the first step was to bend the aluminum shift rod outward so it would clear my leg. Bending the heavy aluminum is a *****, even with a large amount of heat. Luckily the 50 ton press at the shop makes it a bit easier.
Doesn't seem like much yet, but I'll have it finished later this weekend.