[SCOTI]

Depends on your definition....

I installed the brake lines & part of the fuel lines (rear line from the tank). I still need to get some rubber fuel hose to protect the outside of the middle/front fuel lines to isolate them where they route thru the frame boxing & reinforcements.

I got the 3/8" stainless exhaust pipe flanges finished. I mounted the pass side manifold & have been chopping up pieces of tubing to determine the 'right' length of exhaust drop so I can remove/service the starter & not cook the brake fluid to the rear brakes.

I played w/a couple of different pieces after work today to get things close so tomorrow I'll start trimming them to tack in place. Once tacked in place, I'll verify the starter can be easily removed & continue on from there.